MISSION 1 · TIMECODE SYNC

One reference. Every camera.

Use your device clock or jam a reference, then scan each camera.

v0.1 · Accuracy validation pending

Set the reference

Camera capture rate

MISSION 1 modes through 240 fps, including fractional rates. Available modes depend on model and resolution.

30 fps capture · 1 capture frame per timecode frame.

Reference source

Device Clock uses this device’s time. Jam lets you manually match another timecode readout.

Production UTC offset

Includes daylight saving time. Held fixed for this session.

Reference offset milliseconds

Positive moves the reference ahead. One timecode frame = 33.333 ms.

Using device clock.

QR OFF

REFERENCE TIMECODE 30

--:--:--:--

Reading clock…

Ready when you are

Check the reference, then start the QR.

Camera confirmation appears on the camera.

QR hiddenKeep this screen awake

Inspect QR command

Start the QR to see its current payload.

Precision date/time only. No camera mode, record, or calibration commands.

Scan while idle. Point your MISSION 1 at the live QR, wait for its acknowledgment, then move to the next camera.

Slate the take. Jam sync is a starting reference. It does not lock shutters or prevent clock drift. Run a sync test ↗